close
close

How To Read A Digital Water Meter In Gallons

How To Read A Digital Water Meter In Gallons. You can learn how to read a neptune water meter in cubic feet or gallons unit, but. Advance one digit as indicated.1 cubic foot of water =.

5/8" x 3/4" Water Meter (Direct Read, US Gallons)
5/8" x 3/4" Water Meter (Direct Read, US Gallons) from www.vanislewater.com

To accurately read your water meter, pay attention to the last number. This reading should match the meter, located in the pit.(figure Direct read digital digital on the face of the meter, numbers are arranged like the odometer in an automobile.

When Showing Your Reading, Digital Water Meter Reads As Is And Includes A Decimal Point.

The meters are read the same as cubic feet meters. If present, use the odometer reading first. Your water meter reads like a car’s odometer, but with a permanent zero in the gallon place.

10 Million Gallons 1 Gallon.

The meter measures water usage in cubic feet. Read the meter a week later, subtract the first reading from the second to find out how much water was used. 1) 0 is millions gallons (far left 0) 2) 6 is 100,000 gallons

Observe The Flow Rate Screen For At Least 10 Flashes.

Wait 20 minutes then read your water meter again and record the numbers. The meter measures water usage in cubic feet. The meter in this photo is showing actual usage of 53,586.5 gallons.

Purposes The Amount Of Water Used In Gallons Is Rounded Down To The Nearest 1000 Gallons So 4,204.11 Gallons Becomes 4,000 Gallons Billed.

Charges are based on units of 1,000 gallons of water used. Some areas may also apply the earlier method to read. If gallons used is greater than zero you have a continuous leak.

The Sensus Meter Is Read From Left To Right.

Subtract the first water meter reading from the second. The large, red sweep hand on an analog meter is used to measure water in gallons or cubic feet. It is read if your billing resolutions is:

Leave Comment

Your email address will not be published.